Baso G196 Series BASOTROL Redundant Combination Gas Val User Manual download pdf

Installation Instructions

Issue Date March 13, 2013

Part No. BASO-INS-G196, Rev. E www.baso.com

G196 Series BASOTROL® Redundant Combination

Gas Valve with Manual Shutoff Valve

Application

The G196 valves are suitable for use with natural gas,

Liquefied Petroleum (LP) gas, or LP gas-air mixtures.

Typical applications include electronic ignition systems

on residential furnaces, boilers, unit heaters, rooftop

equipment, agricultural heaters, commercial cooking

equipment, and other types of light commercial and

residential heating units.

Installation

IMPORTANT: Only qualified personnel should

install or service BASO® Gas Products products.

These instructions are a guide for such personnel.

Carefully follow all instructions in this document and

all instructions for the appliance.

IMPORTANT: Make all gas installations in

accordance with applicable local, national, and

regional regulations.

CAUTION: Risk of Electric Shock.

Disconnect power supply before making electrical

connections to avoid electric shock.

WARNING: Risk of Explosion or Fire.

Shut off the gas supply at the main manual shutoff

valve before installing or servicing the G196. Failure

to shut off the gas supply can result in the release of

gas during installation or servicing, which can lead to

an explosion or fire, and may result in severe

personal injury or death.

WARNING Risk of Explosion, Fire, or

Electric Shock. Label all wires before they are

disconnected when replacing or servicing the G196.

Wiring errors can cause improper or dangerous

operation and may result in an explosion, fire, or

electric shock leading to severe personal injury or

death.

IMPORTANT: Verify that the valve is installed

only in applications where the specified maximum

ambient (surface) temperature and maximum

operating pressures do not exceed the limits in the

Technical Specifications section.

To install the G196 valve:

1. Shut off power to the appliance.

2. Shut off the gas at the main manual shutoff valve.

3. Label each wire with the correct terminal

designation prior to disconnection.

4. Compare the voltage on the valve with the power

source voltage to ensure the correct unit is being

installed. For valves with 25-volt coils, use a

National Electrical Code (NEC) Class 2

transformer.

Note: The transformer must be mounted to a

grounded metal enclosure.

5. Ensure that the gas flows through the valve body

in the direction indicated by the arrow on the

valve body. If the valve is installed with the gas

flow in the opposite direction of the arrow,

leakage can occur.

1 2 3 4 5

Summary of Contents

Page 1 - Installation

Page 2 - 360 around its axis with

2 G196 Series BASOTROL Redundant Combination Gas Valve with Manual Shutoff Valve Installation Instructions IMPORTANT: Do not use a wrench on any

Page 3 - Setup and Adjustments

G196 Series BASOTROL Redundant Combination Gas Valve with Manual Shutoff Valve Installation Instructions 3 ONOFFONOFFIntermittent PilotIgnition Co

Page 4 - Repairs and Replacement

4 G196 Series BASOTROL Redundant Combination Gas Valve with Manual Shutoff Valve Installation Instructions Regulator Adjustment ! WARNING: Risk o

Page 5 - Technical Specifications

G196 Series BASOTROL Redundant Combination Gas Valve with Manual Shutoff Valve Installation Instructions 5 Technical Specifications Product G196 S

Comments to this Manuals

No comments

Baso G196 Series BASOTROL Redundant Combination Gas Val User Manual

Browse online or download User Manual for Hardware Baso G196 Series BASOTROL Redundant Combination Gas Val. BASO G196 Series BASOTROL Redundant Combination Gas Valve with Manual Shutoff Valve User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Hardware Baso G196 Series BASOTROL Redundant Combination Gas Val